Description:
Cement-based, high-strength, polymer and fiber-modified, water-resistant structural repair mortar.
Advantages:
• High adhesion and durability shortly after application
• Possibility of water-resistant and high-strength leveling and surface smoothing before waterproofing applications
• Surface repair and leveling of high-strength concrete elements
• Filling tie-rod gaps
• Thixotropic properties
Usage areas:
Used for repair of damaged concrete and reinforcement due to corrosion, surface smoothing, leveling, and waterproofing of underground and aboveground structures, and filling tie-rod gaps
• The surface where the application will be made must be clean, dry, and sound, free from dirt, dust, and weak particles.
• The mold to be used for the application must be fixed, sealed, and cleaned very well.
• If the application is to be made on old concrete, the surface must be moistened before the application. Small water accumulations should be avoided.
• The necessary amount of material should be prepared considering the working time.
Application Conditions:
• Ambient temperature should be between +5°C and +35°C.
• Application should not be done in very hot weather.
• Should not be applied on frozen or surfaces in danger of freezing.
Application:
One 25 kg bag of Corion Repair Fix should be poured slowly into a container containing approximately 3.75-4.25 liters of clean water. It should be mixed with a low-speed electric mixer until it reaches a homogeneous consistency for about 3-4 minutes. No additional water should be added to the hardening mixture. The mixture should be left to stand for about 2 minutes before application.
Application Tools:
Electric mixer, steel trowel, putty knife, smoothing trowel, steel wire brush.
Consumption:
1.9 kg/m2 (for 1 mm application thickness)
• Use appropriate safety equipment (mask, gloves, goggles).
• Protect your eyes and face.
• Avoid contact with eyes and skin.
• If it comes into contact with eyes, immediately rinse with plenty of water and seek advice from a specialist.
• Read the Material Safety Data Sheet for detailed safety information.
• The surface moisture level should not exceed 5% before application.
• Primer application must be done prior to application.
• The product must be kept away from sources of ignition and should not be smoked near.
• During application, gloves and goggles must be worn, and contact with eyes and skin should be avoided. In case of contact, rinse thoroughly with plenty of water and seek medical attention immediately.
• Adequate air circulation must be provided in the application area.
• The applied product may yellow over time when exposed to UV light. However, this effect is only visual and does not affect the mechanical properties and performance of the product.
Corion Construction Chemicals shall not be responsible for any application errors that may occur if the product is used for purposes other than its intended use or if the above-mentioned conditions are not followed.
The specified times are valid for surface and ambient temperatures between 20-23°C. The time will be longer at low temperatures and shorter at high temperatures. Corion Construction Chemicals shall not be responsible for any application errors that may occur if the product is used for purposes other than its intended use or if the recommended application conditions and guidelines mentioned above are not followed.