Description:
Water Based White Water Sealant
Advantages:
Creates a long-lasting waterproof layer
Usage area:
Window edges, chimney edges, water gutters, wall cracks, kitchen counters, shower cabin.
Application conditions:
– Ambient temperature +5 °C to +35 °C.
– It should not be applied on surfaces that are frozen, melting or at risk of frost within 24 hours.
– It should not be applied under direct sun, strong wind or on hot surfaces.
Application:
• The product should be shaken well before use. • Spray from a distance of 20 cm from the surface
• The surface to be applied must be dry and free from moisture.
Consumption approx. 100 – 150 g/m2
• Use appropriate safety equipment (mask, gloves, goggles).
• Protect your eyes and face.
• Avoid contact with eyes and skin.
• If it comes into contact with eyes, immediately rinse with plenty of water and seek advice from a specialist.
• Read the Material Safety Data Sheet for detailed safety information.
• The surface moisture level should not exceed 5% before application.
• Primer application must be done prior to application.
• The product must be kept away from sources of ignition and should not be smoked near.
• During application, gloves and goggles must be worn, and contact with eyes and skin should be avoided. In case of contact, rinse thoroughly with plenty of water and seek medical attention immediately.
• Adequate air circulation must be provided in the application area.
• The applied product may yellow over time when exposed to UV light. However, this effect is only visual and does not affect the mechanical properties and performance of the product.
Corion Construction Chemicals shall not be responsible for any application errors that may occur if the product is used for purposes other than its intended use or if the above-mentioned conditions are not followed.
The specified times are valid for surface and ambient temperatures between 20-23°C. The time will be longer at low temperatures and shorter at high temperatures. Corion Construction Chemicals shall not be responsible for any application errors that may occur if the product is used for purposes other than its intended use or if the recommended application conditions and guidelines mentioned above are not followed.