Description:
Acrylic resin-based curing material that prevents rapid evaporation of the mixing water and minimizes the risk of crack formation on the surface by forming a water vapor-proof protective film layer on the pores on the surface after concrete, screed and cement-based surface hardener applications.
Advantages:
• Preventing fast drying and cracking by clogging the pores on the fresh concrete, surface hardeners and screed surface
• Preventing dusting by increasing the abrasion resistance of the surface
Usage areas:
It is used as a material to prevent rapid drying of freshly applied concrete, screed and surface hardeners.
Application Conditions:
• Ambient temperature should be between +5°C and +30°C.
• Application should not be done in very hot weather.
• Should not be applied on frozen or surfaces in danger of freezing.
Application:
• The product should be shaken well before use.
• It should be applied to the surfaces by spraying method in equal amount as a thin film layer.
Consumption:
Approximately 100-150 g/m2
• Use appropriate safety equipment (mask, gloves, goggles).
• Protect your eyes and face.
• Avoid contact with eyes and skin.
• If it comes into contact with eyes, immediately rinse with plenty of water and seek advice from a specialist.
• Read the Material Safety Data Sheet for detailed safety information.
• The surface moisture level should not exceed 5% before application.
• Primer application must be done prior to application.
• The product must be kept away from sources of ignition and should not be smoked near.
• During application, gloves and goggles must be worn, and contact with eyes and skin should be avoided. In case of contact, rinse thoroughly with plenty of water and seek medical attention immediately.
• Adequate air circulation must be provided in the application area.
• The applied product may yellow over time when exposed to UV light. However, this effect is only visual and does not affect the mechanical properties and performance of the product.
Corion Construction Chemicals shall not be responsible for any application errors that may occur if the product is used for purposes other than its intended use or if the above-mentioned conditions are not followed.
The specified times are valid for surface and ambient temperatures between 20-23°C. The time will be longer at low temperatures and shorter at high temperatures. Corion Construction Chemicals shall not be responsible for any application errors that may occur if the product is used for purposes other than its intended use or if the recommended application conditions and guidelines mentioned above are not followed.